> Complete documentation index: [llms.txt](/llms.txt). Markdown versions of all pages are available by appending `.md` to page URLs. # Binho Nova: Hardware reference > Specifications, interfaces and pinout of the Binho Nova. Specifications, interfaces and pinout of the Binho Nova. ## Specifications | Feature | Nova | | ----------------- | ------------------------------------------------------- | | I2C | Controller, up to 3.4 MHz | | SPI | Controller, up to 12 MHz | | UART | Up to 1,000,000 baud | | 1-Wire | Dallas 1-Wire | | Single-Wire | Atmel Single-Wire Interface (SWI) | | GPIO | 5 pins, shared with the bus pins; interrupts and PWM | | Analog | 5 ADC inputs, 1 DAC output (not calibrated, see [FAQ](/support/faq/is-the-adc-calibrated/)) | | Logic level | 3.3 V, fixed | | Power out | 3V3 and VUSB pins | | USB | USB 2.0 Full Speed (12 Mbps), Type-C, USB serial (CDC) | | Power | From USB, 200 mA at 5 V, 1 W max | | Other | Programmable RGB status LED, field-upgradeable firmware, aluminum enclosure | Full electrical data is in the Nova datasheet (rev 1.4). To get it, see [Where can I find the product datasheet?](/support/faq/where-can-i-find-the-product-datasheet/) ## Interfaces * **USB Type-C:** power and data. * **Wire harness:** ends in a female 1.27 mm 2×5 IDC connector: 5 signal pins, one 3V3 pin, one VUSB pin and 3 GND pins. ## Pinout Guide
Binho Nova pin functions by mode

Nova pin functions by mode.

To connect the Nova to the board, see [Hardware Setup: Binho Nova](/hardware/nova/setup/).