Skip to content
binho.io (opens in a new tab)Contact Us

Binho Atira: FAQ

Short answers to common questions about the Binho Atira.

It is an embedded bridge for Arm Cortex-M development. It halts, steps and sets hardware breakpoints, programs the target’s internal flash, supplies and measures a programmable 1.2 to 5.0 V target rail, programs external SPI memory devices, and bridges a UART to a serial port on the computer. See the overview.

It can. It supplies a programmable 1.2 to 5.0 V rail on pin 1 of the Programming Port, and the rail is off when the Atira powers up. Switch it on before any SWD, SPI or UART traffic, even if the target has its own supply: the Atira’s level shifters run from the rail. Self-powered targets are limited; read Target power before connecting one.

Can I use more than one Atira at the same time?

Section titled “Can I use more than one Atira at the same time?”

Each Atira has its own serial number. list_debug_probes() lists them, and DebugProbe.open(serial="...") opens a specific one. An Atira and a Supernova or a Pulsar can be open in the same Python process.

Any Arm Cortex-M target with SWD at 1.2 to 5.0 V. Flashing has been verified on an STM32H503RB with pyOCD, and other Cortex-M devices with a CMSIS pack should work the same way. In Mission Control 3, flashing goes through the chip’s CMSIS device pack: Install a device pack.

Try Troubleshooting, or contact us.