Mission Control 3 Tools

Mission Control 3 opens each tool in its own tab. Start from the home screen, choose a tool, and connect it to an adapter, a probe or a simulated device.

Tool	Use it to
Serial Terminal	Talk to UART devices and serial consoles
I2C	Scan an I2C bus and read and write I2C devices
I3C	Initialize an I3C bus, assign addresses, and run transfers and CCCs (Supernova)
SPI	Run SPI transfers on any of the four chip selects
GPIO	Configure pins as inputs or outputs and watch interrupts
Memory Programmer	Read, write, erase and verify EEPROMs
MCU Programmer	Flash, verify and erase a microcontroller through the Binho Atira (desktop app)
MCU Debugger	Halt, step and set breakpoints in a microcontroller’s program through the Binho Atira (desktop app)

New to Mission Control 3? See Download & Installation.

New to a bus? binho.io has protocol primers: I2C, I3C, SPI, UART.